When oil level in the oltc of power transformer reduces , oil surge relay will act or not

Answers were Sorted based on User's Feedback



When oil level in the oltc of power transformer reduces , oil surge relay will act or not..

Answer / amit vithalani

No, transformer oil surge relay will not operate due to low
oil level on OLTC conservator. It will operate only when
there is a surge in OLTC.

Is This Answer Correct ?    3 Yes 0 No

When oil level in the oltc of power transformer reduces , oil surge relay will act or not..

Answer / sheikh

whenever oil level reduced in a transformer Temperature
of transformer would be high thereupon thermal safety may be
operated to prevent any kind of losses no oil surge relay exist there.

Is This Answer Correct ?    2 Yes 0 No

When oil level in the oltc of power transformer reduces , oil surge relay will act or not..

Answer / renubala.natarajan

No

Is This Answer Correct ?    1 Yes 0 No

When oil level in the oltc of power transformer reduces , oil surge relay will act or not..

Answer / er.rajeevsaini

No it will not

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

How good are you in resolving the commercial issues to Employer's advantage?

0 Answers  


Enlists the applications of sampled data systems?

0 Answers  


Refernce currents are to be generated using refernce cueernts how can this be done

0 Answers   ABC, Wipro,


percetans

0 Answers   Bhel,


How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point

0 Answers   cpgn,






why the flooring of substation is done with small pebbles or stones..?

16 Answers  


how to revers the direction of single phase motor

0 Answers  


how to make a solar panel? why solar panel cell connected to serious?

1 Answers  


Define newton's law of viscosity.

0 Answers   Godrej,


What are insulation classes? Tell examples of each of them.

1 Answers   IOCL,


AC voltage only create magnetic flux in coils, but in Solenoid coil how 24V DC volt create flux and pick the plunger

5 Answers  


Am using an electronic digital display to see the RPM of ABB ACS 550 drive, which is showing negative value when the motor & drive in stop mode but it is showing correct value during the run mode. can anyone help me out??

2 Answers   Bala Power Solutions,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)