Interested to Buy Any Domain ? << Click Here >> for more details...
As per the Anchor capstan motor specification, full load
current is 200A. starting current is 1750 A and
acceleration time is less than 8 seconds. Please guide for
selection of cable size.
- 0 Answers
- 1885 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
why the capacity of power plant is given in MW though the generators are rated in MVA?
What is x/r ratio?
what is IP65 & What is its advantages
how to calculate the earth fault current
what is the difference between KW and KWh?
when two gen set runing in parallel but thay have diffrent pole pitch, then what will be happan
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
what role does a star point or neutral point play in a star connected system?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
i have dry type transformers can you help me that how many tests i can do to know the performence of transformer and also please tell me about the BDV test and Insulation resistance test in oil cooled transformers
why using in cable mm square which is mm & which is square why using mm & square.
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
