Answer / rajendra

DOL- DIRECT ONLINE STARTER
we use one contactor,one thermal o/l relay
in this connection we use the contactors NO contact parallel to contactor coil after stop push button,
when we push start P/B and realease it at this time the NO
contact becames NC and the contactor run continously.

How to see the inductance in a transmission lines

0 Answers  

---

What is pi controller?

0 Answers  

---

what is blocking diode and what is the use of it in tne control circuit.Pls Explain it.

1 Answers  

---

why high speed tripping relay will be used in tripping circuit why not normal relay

0 Answers  

---

I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.

0 Answers   NCC,

---

how to calculate the ct burden?

1 Answers  

---

A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?

0 Answers   L&T,

---

Require Generator Capcity ( KVA ) for 3 Phase Motor having 4.7Kw with starting current of 16amps?

1 Answers  

---

Why we are checking the vector group & turn ratio of Xformer while PM?

1 Answers  

---

Whats the purpose of neutral earthing?

5 Answers   Electrical, Hindalco, TCS,

---

How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.

0 Answers   Raychem RPG,

---

what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?

0 Answers  

---