What is pi controller?
No Answer is Posted For this Question
Be the First to Post Answer
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
How to know of any cable size if there are not written on cabl?
What is PMG and AREP excitation system in generator
what is the difference between LPF and UPF wattmeter and where it is used.
What is the difference between voltages or potential difference? And what are they?
sir , what happen if we decrease ( approx 3 inch ) the lenth of shaft in 110KW Induction , three phase motor. actually a 110KW motor is couppled with star couplling to 120TR compressor. When we doing maintenance in compressor it is required to skid the motor backword and resulting dis- alightnment . so we want to change the tyre coupling in place of existing coupling. so it is required to cut off the rotor aprox 3 inch form driving side.
when we start the tube light, then it takes initially 1100 volt, after glow it takes 120 volt?(when we give 220 volt a.c.)
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
why dc is not given to transformer
A 230 v dc series motor is connected to 230 V ac supply, then