Answer / arvind kumar pal

Power factor is nothing but angle between voltage and current. As the angle increases means pf lags result high requirement of currents which creates voltage drops. Therefore it can damage the equipments as equipments are designed as per their voltages

Answer / saqkhu

The disadv of lag pf is that it causes the voltage regulation
to increase towards maximum value due to which the o/p volt
decreases.
volt reg= (V no load - V full load)
= IR cos phy - IX sin phy
in case of lag pf the current is lagging i.e I<-phy
so , the volt reg
= IR cos phy + IX sin phy is more

Why transformer neutral earthing? What is advantages?

3 Answers  

---

HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii) DELTA LOAD, USING A CLAMP METER. NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO WE GET?? PHASE CURRENT OR LINE CURRENT.

13 Answers   Bhel,

---

what is the difference between dropout fuse and horn gap fuse. how to choose between them

1 Answers  

---

can anyone provide me a amf panel control wiring using ec-2 relay?

0 Answers   Electro Tech,

---

WHEN I AM CONNECTIN TWO ELCB IN PARALLEL.ONE ELCB TRIPPED...HOW IT HAPPEND??

5 Answers  

---

What do you mean by reverse current braking of an induction motor?

1 Answers  

---

When star connection of motor is use?

1 Answers  

---

What is maximum permissible length of cable from transformer (33kV/0.433kV) HT side to HT panel which contain VCB? In which standard i shall get this information.

6 Answers   MSEB,

---

What is the effect of impedance on the heat losses in case of AC system??? Does heat losses really depends on the impedance or depends only on resistive component only..??

4 Answers  

---

What do you mean by 4.44 in this transformer equetion E=4.44 nfqm

4 Answers   Bharat Bijlee,

---

what about GD square and its important for motor design?

0 Answers   Innovis, MNC,

---

Define maximum demand?

0 Answers  

---