what is the disadvantage of lagging power factor & why ?
Answer Posted / saqkhu
The disadv of lag pf is that it causes the voltage regulation
to increase towards maximum value due to which the o/p volt
decreases.
volt reg= (V no load - V full load)
= IR cos phy - IX sin phy
in case of lag pf the current is lagging i.e I<-phy
so , the volt reg
= IR cos phy + IX sin phy is more
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
What is the disadventage of gland earthing(power cable) if any. ?
how to commissioning the genset with amf panel?
why are installed water leakage detection system data centers & server rooms
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
While testing a ZCT what parameters have to check or measure?
Explain thin film resistors and wire-wound resistors
How PADO software increase the efficiency of power plant?
Define pole pitch?