WHAT IS THE DIFFERANCE BETWEEN IP54 AND IP55
Answers were Sorted based on User's Feedback
Answer / abhishek kesarwani
see the first digit stands for protection against solid and
second digit stands for liquid protection...
IP 54:- 5 (first digit)- limited particles of dusts can
enter in the panel,
4 (second digit)- if the water is splashed from any
direction then also it can not approach to the components.
IP 55:- first digit is same so please see above.
5 (second digit) The panel shall be protected against low
pressure jet from any direction.
Hope my answer shall satisfy.
If any more clarification needed please send mail on my mail
id so that i can reply you.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / neeraj dubey
IP54 enclosures have a high level of protection against particles, and a fair amount of protection against water and IP55 enclosures that demonstrate almost complete protection from particles and a good level of protection against water.
| Is This Answer Correct ? | 2 Yes | 1 No |
Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.
Generally In transformer Tap Changer on HT side, but I have seen in 66KV side in 220/66 KV, 100 MVA, Areva make transformer. Why ?
There is no such thing as a Generator. All power generating devices are Alternator since both generate alternating current since this is the only way electrical power can be generated. In "generators" the alternating current is converted into DC inside the housing of the "generator" in order to give out DC Do you agree? If not please educate me. How else is DC generated if not like above?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
Explain the operation carried out in thermal power stations?
What meant by XLPE cable
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
1.two coupled coils with L1=L2=0.6 H have a coupling coefficient of k=0.8 the turns ratio N1/N2 is......
Why not implimenting power factor in Diesel generator
Which is remain unchanged in transformer action?
how to select earthing wire? procedures and parameters?
formula for incomer breaker size calculation of powerfactor correction unit
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)