Is it recommended to apply H.pot test for new cables
segments after terminations or joints, however, this cable
has been tested before at the manufactor by the vendor ? or
only we can apply megger tests ?
Answer / sudhakar g
Hpot is the test we can do if any cable damage happend or any leakage of current....Every cables must be tested before they sent to consumer and the test certificates also provided when ever we buy that product....Before terminated to any transformer or panels or any equipment...We have to do the megger test because if there is any cable damage while we are laying the cable....If you go for high rise buildings it is recommended use Rising main, you will tap the supply from the Rising main and main advantage is voltage drop is not occur compare to cable laying.......
Is This Answer Correct ? | 1 Yes | 0 No |
why ct output is in 5A?
What are protection of power transformer?
why we use the fuse in only one wire? althrough in ac current the current flows in both directions. why the neutral wire can be taken half the magnitude of phase wire while same current returns from neutral wire?
what are the different types of bus bar used at electrical work at shelter
3 Answers Aster Teleservices, Costco,
Does the isolator has a making capacity????????
i have 28/32 MVA power transformer with 11/6.6 KC voltage rating and 12%impedance.it have star connection at both side.but it have another thied winding tertiary winding.what is used of this winding. pl tell me
in non technical way how can u define POWER FACTOR??
which type of capacitor store high amount of energy for long time ? ( polarized or unpolarized )
Explain the operation of grid connected central solar inverter ?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
How capacitor connect in 3 phase supply???
what is polarity in ac system? and how do identified?