Answer / sriman

Isolators are mainly for switching purpose under normal
conditions they cannot operation in fault
conditions.Actually used for isolating the CBs for
maintanence.
Where as CB gets activated under fault conditions according
to the fault detected.
Bus bar is nothing but a junction where the power is
getting distributed for independent loads.In single word it
is One to Many.

i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com

0 Answers   RRB,

---

WHY KVAR IMPORTANT WHEN ANY PLANT IS RUNNING ON IT'S OWN POWER PLANT?

1 Answers  

---

one KVAR takes how much amps, and how to add power capacitors to electrical panels, for example if one of the MCC drawn 800amps means how much KVAR required

1 Answers  

---

what is rated current and operating current?

1 Answers  

---

I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?

0 Answers  

---

What is the difference between circuit and network.

15 Answers   Jadavpur University, Sail, TCS,

---

If I have a LT panel 3ph, 415V, 50Hz which demand load-600kw, how we can calculate its body earth strip size.

1 Answers  

---

how to reduce the co level in your 1000kva dg set side?

1 Answers   Cognizant,

---

WHAT IS LINIER MOTOR?

4 Answers   BSNL, wbsedcl,

---

Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?

0 Answers  

---

I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??

0 Answers   Elmaco,

---

what is earth resistance? how to measured? and give values at power station and mcc area?

0 Answers   Essar,

---