Answer / raju.tanuku

two type of elements 1) primary elements 2)secondary elements

How we are deciding while programming in pid controller , What we are using heating or cooling.

1 Answers  

---

if I did short to both AO connections, channel will burn or what? m sure in AI it will damage to channel. But what will happens in AO?

1 Answers  

---

how to replace the smart transmitter software

1 Answers   L&T,

---

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

0 Answers  

---

Convert a pressure, level, flow, or temperature process variable value into the appropriate pneumatic or electrical value given different types of instruments.

6 Answers   Jindal, MCL, Thermax,

---

I want to know if flowrate increases in 16' pipe line what will happen to upstream pressure and why?

1 Answers  

---

Is there’s power on the bus (if so, state whether on the signal bus, or on a separate in the following: a) HART b) Profibus DP c) Profibus PA d) DeviceNet e) Foundation Fieldbus

1 Answers   EIT,

---

what is positive feedback and negative feedback?

2 Answers   CEPC,

---

i am confusing about differential pressure transmitter as i seen so many DPTs in different ranges how can we calculate level and flow with mmh20 plz tel me

1 Answers  

---

What is the difference between instrument earthing and normal earthing? and why is it necessary to do so?

3 Answers   Atul,

---

What is Loop Test & What is Loop Checking? Please i need answer for these questions.

2 Answers  

---

WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND INSTRUMENTATION TRANSMITTERS?

3 Answers   Aban Power, Jindal, JSW, Sugar Factory,

---