what perpose of use CT ratio in gt,st,uat
primary current
/
secondaru current
or 1 or 5 amper
ct berden /fits whit relay or ampermeter
I'm from Iran
My English is not very good
Excuse me for this problem
Good luck
| Is This Answer Correct ? | 0 Yes | 0 No |
What are the different auxiliary protections of a transformer?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
Can Induction motor run at over rated speed? ( 15oo rpm is rated speed for 50HZ. is it possible to ride 3000 RPM with same motor with the help of VVVFD for continues ride of 100HZ)
how much current will take for 1kw power. and what is the eqoutiion which is connecting with kw and A.
what is means of ALF,kPV(min),lexc(max)at Vk,Rct@75 degree centrigate ohm in current transformer name plate?
what are the interview question asked in wind mill about electrical
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
what is the requirement regarding earthing of Single conductor with AWA
what is current check gurd relay?
if the diameter of a conductor is 'R' then what is the distance between two bundle conductor in a phase?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)