why we use 110vac in overhead crains? why not 220v, 24v

3 Answers   SOFT,

---

I have 2 Nos of 2500kVA 33/0.415V cast resin transformers. How to decide on ampere rating of HT Panel? Also advise me how many panel RMG i have to consider whether 4 panel ok?

1 Answers  

---

If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses

0 Answers   Kirloskar,

---

why power factor laggs and leads in case of inductance and capacitance??

1 Answers  

---

In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.

0 Answers   PCE,

---

What are the RGGVY, APDRP, RE?

3 Answers  

---

why and how voltage sharing in transformer, during magnetic balance test ?

0 Answers   ME,

---

Show Details FROM:Muhammed Ikram TO:qa@allinterview.com Message flagged Saturday, June 4, 2011 10:07 PMMessage bodyHello all, i want to ask a question to all of you that what is VMM (voltage monitoring module )? how it work,s? i heard somewhere that it compare 1 phase voltage to other phase voltage. but there is also some setting on it. how to set it,s setting. please tell me briefly. Thank,s and Regard,s. Muhammed Ikram.

0 Answers  

---

What is the role of ESP(Electro Static Precipitator)in steam power plants? Where it is located? How it works?

1 Answers  

---

Two 11 kv lines are feeding to common bus in a substation,I have one set of CT & PT(3ct,2pt), How can I measure both lines power using single set.

6 Answers   L&T,

---

There is one 40MVA oil cooled transformer (yet to commission), filled with 95% oil and we are trying to fill 5% Nytrogen in that transformer so that there should not be any foreign component inside. But even though there is no leakage, nytrogen is not withstanding inside transformer, within a day or two pressure guage is showing 0. Why is it soooo? Pls reply.

1 Answers  

---

why the Parameters : Base Voltage & Maximum Voltage can't be equal in value in a VFD (Variable Frequency Drive) ? How much the base voltage would be lower than the maximum voltage ? If 400 V is the 3 phase output of a VFD ... then what should be the base voltage ? thanks a lot

1 Answers   Yaskawa,

---