Answer / balaji kulkarni

When MOS devices are built up on same substrate the body
effect does not comes into consideration,however for complex
circuits it contributes significantly.
It can be stated as "Additional potential drop that occurs
across the depletion region because of Body potential that
adds up to threshold potential,there by increasing total
voltage drop across the junction".It increases with increase
in Gate-Oxide thickness..

which remote subscriber provide voice communication?

0 Answers  

---

Why 16 Signaling links are the maximum links between two GSM switches?

1 Answers   Ericsson,

---

What is the differences between microprocessor and micro controller?

0 Answers  

---

Explain full duplex and half duplex.

0 Answers  

---

what are flag in microprocessor

5 Answers   BVSJ, DOEACC,

---

What is a scrambler? Explain its operation

0 Answers   CUTM Centurion University of Technology and Management,

---

What is the height of BTS?

1 Answers   NSN,

---

what is AM,FM,& PM

2 Answers   IETE,

---

An FM receiver has an IF frequency that is A 88MHz-108MHz range B 540kHz-1640kHz range C 455kHz D 10.7MHz

2 Answers  

---

Explain how to convert design gray to binary code?

0 Answers  

---

It is said that buffer is used when any circuit has to drive large outputs. why is buffer used?

1 Answers  

---

an unknown semiconductor has Eg=1.1ev and Nv=Nc.it is doped with 10^15 donors,where the donor level is 0.2ev below Ec. given that Ef is 0.25ev below Ec, calculate ni and the concentration of electrons and holes in the semiconductor at 300k.

1 Answers   Universiti Malaysia Pahang,

---