Answer / Abhishek Yadav

When making a hole in the surface of a simple supported beam, it is essential to avoid weakening the structural integrity of the beam. Ideally, holes should be made away from the load-bearing areas and at locations where stress concentrations are minimized. However, the exact location depends on various factors such as the type of material, size of the hole, and the loading conditions. It's best to consult with a structural engineer before making any modifications to a beam or similar structure.

shape of aggregates used in concrete should be rounded/cubical or elongated/flaky.

9 Answers  

---

at the beam-column junction point tell me how much beam bars should pass through column ring ? 3 or 2 or 1 . answer with reason. if it is not happen then what will be he effect ?

1 Answers  

---

How will you provide reinforcement from corrosion?

2 Answers  

---

What is the maxi. percentage of steel in compression memeber of C/s area & what is minimum dia for compression member as per IS 456:2000?

1 Answers  

---

size of the traditional brick is 248*121*71 in mm,but why the size are like this.why the size are not like that 211*154*75 in mm

1 Answers   Merlion,

---

how many brick in 1 cubic meter with mortar ?

9 Answers   Electrical, SV,

---

how is shear resisted in a structure?

2 Answers  

---

how to nfind out the specific gravity of sand.aggregate,water please help...

1 Answers  

---

6. What would your co-workers say about you?

0 Answers  

---

How could I calculate quantities of fine aggrigates(sand) & coarse aggregates in pcc M15

1 Answers   Coromandel, RECPDCL,

---

How much quantity a carpenter can do in a day

1 Answers  

---

what is gunter's chainm. what is yhe number of links in chain. and 1 link shows what distance

1 Answers  

---