suppose we have a tendency to make a hole on the surface of
the simple supported beam, than where we goes to make it?
- 1 Answers
- 2156 Views
- I also Faced
- E-Mail Answers
Answer Posted / Abhishek Yadav
When making a hole in the surface of a simple supported beam, it is essential to avoid weakening the structural integrity of the beam. Ideally, holes should be made away from the load-bearing areas and at locations where stress concentrations are minimized. However, the exact location depends on various factors such as the type of material, size of the hole, and the loading conditions. It's best to consult with a structural engineer before making any modifications to a beam or similar structure.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can i get civil engineering test papers.......?????
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
material used for mendrel use to bend epoxy coated rebar
pls send me interview question paper with answer of EIL/AAI/UPSC/RPSC because i am doing prepration of compitation exam of UPSC for the Asst. Executive Engineer
HOw much % of premium on DSR-2013 currently
What is Density of cement, sand & aggregate ?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
I need to constructive work in amaraj batteries
Technical Question of Civil Engineering
Which is the latest version of solidsworks?
Please tell me Detail cost of providing& laying nominal mix design 1:2.5:5,40mm nominal size.curing complete e/c cost of form work in foundation and plinth i/c carriage.
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 100 microns?
minimum number of bars in a beam? minimum and maximum column size and beam size ? minimum and maximum aggregate size used in multistorey residential building for columns,beams,slabs?
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
Suggest how many column, beem, etc required for 30 mtrs x 21 mtrs width x 8mtrs height for industrial shed of ground floor. I want to know the quantity of tmt steel consumption and Concrete consumption for budgeting
