Answer / mike

ActivityFootcandlesLux Hallways5-755-75
Entertaining10-20110-215 Dining10-20110-215 Easy
reading20-50215-540 Bathroom20-50215-540 Kitchen—basic
lighting20-50215-540 Kitchen—food prep50-100540-1075
Difficult reading or writing50-100540-1075 General workshop
lighting50-100540-1075 Fine or detailed work100-2001075-2150
- See more at:
http://www.the-house-plans-guide.com/lighting-calculation.html#sthash.RScVEhq0.dpuf

Answer / gallabhaskar84

waiting for the answer

(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)

0 Answers  

---

This is about the recent problem that we have faced in our project site. We have 6/7.5 MVA. 66/11kV three phase star - star power transformer. The neutral was solidly connected to the earthing mat. But because of high resistance of earthing mat (130 ohm on LV and 180 ohm on HV), one day LV side neutral earthing conductor melted and we had a huge damage. Can any one plz tell me what might happen when we connect power transformer neutral to the earthing mat which has high resistance (>100 ohm ) ?????

2 Answers  

---

In a 3 pin plug holder, what is the purpose of diameter of ground pin is larger than phase and nutral pin

9 Answers   Coal India, HCL,

---

What is VSCF windelectrical system?

0 Answers  

---

What is meant by reactance voltage?

0 Answers  

---

if we convert ampers into kwh or mwh ,which one formula use by us,pls tell me?

3 Answers  

---

If rotor works in clock wise what happens

0 Answers  

---

Why should we hire you over the others waiting to be interview?

0 Answers  

---

What is the approximate value of stacking factor?

0 Answers  

---

what the good value of earth resistance test

3 Answers  

---

super position theorem is applicable to

1 Answers  

---

what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero

0 Answers   Jindal,

---