why AC voltage source are generate as 50 Hz ?
Answers were Sorted based on User's Feedback
Answer / skeeter
Synchronous sources operate according to the equation:
(Hz) = (Poles)*(RPM)/120.
Generation can occur at any frequency that meets this
condition. Every electrical distribution network has its
preferred freqeuncy; North America is predominantly 60 Hz,
while Europe and Asia tend to favor 50 Hz. However, several
other frequencies also exist - ranging from 25 Hz to
several megahertz.
Is This Answer Correct ? | 2 Yes | 1 No |
5o Hz is the standard frequency in india, technically the
frequcy produced by the Ac genrater depends on F= Number of
poles*Speed of generator/120 which is equal to 50 HZ for a
4pole 1500 Rpm and running speed of generator is 1500 RPM
Is This Answer Correct ? | 2 Yes | 2 No |
Answer / g.oopi
INDIAN STANDED ALL THE LOAD IN 50HZ BASED ON DESING OF
MANUFA... TO ALTERNATOR Ns*p/120 s0 positive cycle &-ve cycle
in 50hz where Ns=1500rpm
Is This Answer Correct ? | 0 Yes | 0 No |
This is standared in india AC power is produced at 50 hz
frequency out of india it's 80 hz. Due to this sign wave of
current and volatage complete grah.
Is This Answer Correct ? | 1 Yes | 10 No |
how can decide the current rating of oltc
Will The Rated Capacity of 20 MVA ,220/6.6 KV, ONAN cooling Power Tranformer be increased up to 25 MVA with respect to its %Impedence by ONAF cooling with same rating..?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
How much CTs are required to measure th curent in DOL starting of motor?PLs explain.
Why we can't start a tube light without a starter(choke) and an inductor?
What is maximum permissible length of cable from transformer (33kV/0.433kV) HT side to HT panel which contain VCB? In which standard i shall get this information.
if the voltage across the lamp drops by 1%, the power drawn will be reduced by how many %?
how calculate the current faut level
Why neutral has to switch on-off with phase in TN IT TT systems i.e neutral should be taken as fourth pole
Why is water motor not taking the pressure? what is the problem?
Why we are getting low voltage in star connection?
Why r u using pf panel. what the uses