While finding the velocity of gear B , in case of a simple
epicyclic gear train, why do we take tke velocity of gear A to
be ZERO(0)if the arm is rotated with speed equal to that of
gear A and in opposite direction?
- 0 Answers
- 1523 Views
- MNC, I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
What is the function of a thrust bearing?
Can some one please show me the design of a POT Bearing.
0 Answers General Motors GM, GM General Motors,
what is compression ratio? why its decreased when gear shifted ?
define boiler parts,types and working
Crankcase oil mist detector
boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.
in a centrifugal pump .. when we close the delivery valve partially .. does this increase the pressure before or after the valve .. and why ??
what are the supports using in critial pipe line and what are the type of support using oil&gas, power plant.
what is 5 element level controller using in boiler.
"In steam boiler, what are the various test in water boiler?"
1 Answers ABC Inc, RRB, Siemens,
why we are not doing purging R410a refrigerant in hvac?
What does 0.125 inch stand for in 0.125 inch npt thread?
-
Civil Engineering (5085) - Mechanical Engineering (4452)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
