Answer / shengjun zhou

I noted that most hardened concrete sample have some shortening by 0.5~1% during hardening process possibly especially for low strength concrete (<40 MPa) due to bleeding or plastic settlement. Such shortening would lead to an increased density in hardened concrete sample by similar amount or slightly less for high bleeding case.

difference between trapezoidal and pedestal footing and how the load acts on that

0 Answers   Golden Construction,

---

How do you compute moisture correction using the parameters gathered from Nuclear Density Gauge Apparatus and the moisture contents results from the lab.?

0 Answers  

---

How could I calculate quantities of fine aggrigates(sand) & coarse aggregates in pcc M15

1 Answers   Coromandel, RECPDCL,

---

What is rate for brick masonry work of 1.0 m3 in cm 1:6?

0 Answers  

---

what is the meaning of laitance

4 Answers   Maytas,

---

mix design procedure, i.e m15 to m40

1 Answers   Power Grid, SMG,

---

what is conventional shuttering rate per square feet of built up area? what is Mivan shuttering rate per square feet of built up area? what is coupler shuttering rate per square feet of built up area?

0 Answers  

---

plz tell me the most used units and their conversion in civil engg?

1 Answers   L&T,

---

what is the stirrups? and which condition it is used?

6 Answers   CCCL,

---

how to calculate the runner (2*3) qty in cft. the length is 8 feet.

6 Answers   CCCL, Gammon, Greenko, L&T,

---

How to Calculate the amount of Cement mortor required only for 12 or 10 mm bonding? I mean to know only the amount of mortar for bonding not for plastering. Help me to find this.

1 Answers  

---

Brick size ? & 1 square feet brick work for use brick

1 Answers   Ashoka Electricals,

---