What is difference between dc three point starter and dc four point starter?

Question Posted / boo123pavani

3 Answers
7866 Views
Chettinad, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is difference between dc three point starter and dc four point starter?..

Answer / boo123pavani

In three point starter NVR (no voltage relay)is series with
Shunt if voltage falls certain value NVR De energized due to
insufficient magnetic field and motor turned off. But in
four point starter NVR energized directly from DC supply
thus the draw back of 3 point starter rectified

A motor can be run for a higher speed than normal speed by reducing the field current. reduced the field current may not produce enough magnetic force to hold the handle in on position. so handle returns to off position. this is the disadvantage of three point starter.this is the advantage of four point starter. it will not returns to off position

Is This Answer Correct ?

5 Yes

1 No

What is difference between dc three point starter and dc four point starter?..

Answer / rahul jadhav

No diff.

Is This Answer Correct ?

0 Yes

0 No

What is difference between dc three point starter and dc four point starter?..

Answer / pritish

the difference between a 3 point and 4 point starter is, 4 point starter can be used for over load protection where as 3 point starter can not be used for over load protection and other difference is 4 point starter has 4 terminals and 3 point as three terminals.

Is This Answer Correct ?

2 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

How can i calculate heat load ?

3 Answers DSSR, NSN,

what happen when dc supply is given to the transformer

9 Answers Bhel,

What is the difference between line Distance protection and Line Earth Fault Protection?

1 Answers

what you have to see after one week or month from the day of installation of transformer ?

0 Answers

What is the function of UV coil ACB?

6 Answers DLF,

if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??

0 Answers

why we use lamination or layer by layer cor used?

4 Answers

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers Air Force,

explain supply side and demand side energy management with advantages & disadvantages

0 Answers

Stator of 3-phase IM has 3 slots per pole per phase, calculate number of stator pole pairs. A 1 B 6 C 2 D 3

2 Answers

how many parameters can integrate with fire alarm basically ?

0 Answers Schneider,

what types of cable used in underground coal mining?

0 Answers

For more Electrical Engineering Interview Questions Click Here