How would you supply power to a village which is very far from a sub-station an

How would you supply power to a village which is very far
from a sub-station and has only a 11k?

Question Posted / guest

4 Answers
8643 Views
Power Grid, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How would you supply power to a village which is very far from a sub-station and has only a 11k?..

it depends on how far the village is situated.considering the line losses 11 kv distribution may not be economical so we have to step up it to 33 kv and then transmit and then step down to 33 kv to 11 kv to 430 V.

Is This Answer Correct ?

16 Yes

1 No

How would you supply power to a village which is very far from a sub-station and has only a 11k?..

Answer / vijay shinde

if we have only 11kv then again step up the voltage in
33kv and transmite it then step down in 11kv

Is This Answer Correct ?

17 Yes

4 No

How would you supply power to a village which is very far from a sub-station and has only a 11k?..

Answer / ramkumar

the distance is high line losses are increases.so voltage
drop will be occur. so increase in voltage,minimise the
losses and voltage drop.so increase the voltage 11kv to
higher rating.

Is This Answer Correct ?

3 Yes

0 No

How would you supply power to a village which is very far from a sub-station and has only a 11k?..

Answer / surender kumar singh

As usual Voltage stepping up action is needful.
Level of transformation will be based upon distance between sending end & receiving end.
Slabs of voltage stepping up & down applicable for suitable voltage correction & compensation of line losses to cater power at village.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why should the primary of transformer be connected in delta in a heat run test?

0 Answers Bhel,

what is pf. how to calculate capacitor bank value to maintain unity pf.

18 Answers JH, Saint Gobain, Supreme Treves,

HOW TO CALCULATE EARTHING SIZING?

0 Answers L&T,

what is the roll of power factor in induction motor.

3 Answers Hindalco,

Why the motor take high starting current for long time(10- 15 sec) which is connected to Blower as compaire with a motor which is connected with pump with same rating?

2 Answers

how to calculate full load current of transformer & induction moter ?

2 Answers

why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)

0 Answers

why the Parameters : Base Voltage & Maximum Voltage can't be equal in value in a VFD (Variable Frequency Drive) ? How much the base voltage would be lower than the maximum voltage ? If 400 V is the 3 phase output of a VFD ... then what should be the base voltage ? thanks a lot

1 Answers Yaskawa,

meaning of two lines in between the transformer single line diagram??

3 Answers

How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.

0 Answers vssc,

When a fourth resistor is connected in series with three resistors, the total resistance

1 Answers ITI,

What is the meaning of dedicated earthing?

0 Answers Dabur,

For more Electrical Engineering Interview Questions Click Here