Answer / kaushik4454

Friend,
Both loop test and checking are same in practically.
simulate 4 to 20 through hart/bt/hht. OR transmitter itself.Smart transmitter also have the facility to simulate ma.

Answer / raja

loop test mean hart communicator connect the transmitter
than simulate the MA 4MA to 20MA transmitter to DCS system

what are use for loop check

Loop verify the tag number transmitter to DCS system
verify the range the data sheet range transmitter to DCS system

Name some of the common protocol use in automation.

3 Answers   Empower,

---

Describe all types and levels (4-20mA, 0-10V, mV, pulse, etc.)of analog and digital I/O used in process control application.

2 Answers   Jindal,

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

0 Answers   Hospira,

---

what is ZERO SUPPRESION and ZERO ELEVATION?

3 Answers   Reliance,

---

What is the difference between Error and Offset.

1 Answers  

---

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

0 Answers   TNPL,

---

What is the purpose of LO Overhead tank in turbines.

0 Answers   ADMA OPCO,

---

what does it mean an active front end in vfd plz explain it briefly

0 Answers  

---

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

Where should we terminate the shield and why?

3 Answers   OPaL,

---

square root calculation for dp flow transmitter? give me a explanation with example

3 Answers  

---

What is the difference between fire detector and smoke detector?

5 Answers  

---