installation process of orifice,a question asked for confusion creation in interview by BARC
1.if orifice is tightly fitted with pipe ,it will act like venturi
2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
No Answer is Posted For this Question
Be the First to Post Answer
What is calibration?
how bolometer is used in temperature measurement ??
can any one pl explain me in brief that how we select the leakage classification in valve,means for liquid or gas there is any standard for selecting leakage classification or its depend upon valve size or any any other parameter.
what is the si unit of pressure?
6 Answers HTA Instrumentation,
what is modbus,profibus,fieldbus
if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?
Explain , how timer based pneumatic control valve will work ?
How to adjust the zero & span of a control valve from the posiitioner(MIL)?
what is stability
what is lead lag compensator and for wat v using that???
If the vibration probe near to the shaft,then output voltage will be decreased r increased?How?
1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?
3 Answers EI Electrotechnical Institute,