why starter use to on a motor
Answers were Sorted based on User's Feedback
Answer / deshmukhgs
to avoid burning of the motor because of high curent
| Is This Answer Correct ? | 12 Yes | 1 No |
Answer / mohsin jamil
because motors start slowly with high torque and bcz of high
torque it needs high amp until it reaches to its full speed..
thats why we use Star connection or start the motor slow so
that motors winding doesn't burn
| Is This Answer Correct ? | 6 Yes | 2 No |
Answer / muthu kumaran
initially there is no back emf in motor and so current due to the supply voltage flows fully thru the motor.
for EX:230v supply resistance of motor is 0.15ohm -->I=230/0.15=1350.but the rated I is 45A.so that the motot gets damage.so we need to use the starter
| Is This Answer Correct ? | 2 Yes | 0 No |
At the starting time 'EB=0'(back emf) so that
motor draws a 2 to 3 times of its full load current
and which cause to damege the winding. ummm....
That is why using stater to reduse starting current
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / simpson
when the motor is in off position the starting winding’s
resistance is 0 ohm .If in this condition 3 Phase 440 v is
directly applied on it the result will b blow of the starting
winding .Hence huge amount of heat will produce .
| Is This Answer Correct ? | 0 Yes | 1 No |
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
How wti of transformer works?
Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua
what is a FACTS devices? what is mean by STATCOM????
how to calculate cable size by amp
how to calculate unit consumption on 3phase 380-415 v0lt kilowatt motor eg ( 55kw,380v,3phase 50-60hz)
How much load can be taken for chiller from 1500 kva transformer
1.why ACB is not connected in HT side what Happens? 2.how much voltage maintained in ACB breaker? 3.OLTC is connected in primary side in case secondary side connected what happened?
How does flights get the neutral(grounding)
How to select the releases for MCCB ?
what is the role of energy meter in distribution system ?
how many by pass system in online UPS.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)