HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF RELY

HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF
RELY

Question Posted / royiype

3 Answers
5585 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF RELY..

Answer / k.prakashchandra

All cts in parallel and REFR in series with NCT

Is This Answer Correct ?

3 Yes

0 No

HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF RELY..

Answer / royiype

P1, P2 & S1 S2 DIRECTIONS OF CTS, HOW MANY CTS IN 3PHASE
4WIRE SYSTEM AND CT DIRECTIONS

Is This Answer Correct ?

0 Yes

0 No

HOW WE WILL CONNECT THE PHASE CTS AND NEUTRAL CTS TO REF RELY..

Answer / rajesh

WHY DO WE NEED CT IN NUETRAL

BECAUSE METERING IS DONE OF PHASE AND THERE IS NO CURRENT IN A BALANCED SYSTEM.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What are the two types of transistor and how they are made?

2 Answers

why generator efficiency is more in swinburnes test?

0 Answers

how many types of cbs?with pcific ratings?

1 Answers Bhel,

WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA

0 Answers BMC,

operating Lt & HT voltages used in India?

8 Answers Essar,

what determins the amount of voltage produced by a voltaic cell?

1 Answers

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

0 Answers

What is the function of the circuit breaker failure relay?

0 Answers

Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards

0 Answers

bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.

1 Answers

HOW TO CALCULATE CT AND VT RATIO IN PRTECTION AND METERING?

1 Answers College School Exams Tests, L&T,

in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.

0 Answers

For more Electrical Engineering Interview Questions Click Here