if we put any thermocouple on a table in a room without any connection,what te

if we put any thermocouple on a table in a room without any
connection,what temperature should it show.

Question Posted / deepak naik

3 Answers
7210 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if we put any thermocouple on a table in a room without any connection,what temperature should it ..

Answer / deepak

as we know working principle of thermocouple , mv generation
is function of temprature difference between hot and cold
junctions, in above case we are keeping thermocouple on
table in room .means both junctions at same temprature hence
it should be shown zero temprature.for example,
if room have 30 degree temp.then hot -cold= actual temp
30- 30 = 0

Is This Answer Correct ?

33 Yes

2 No

if we put any thermocouple on a table in a room without any connection,what temperature should it ..

Answer / siva

what the room temperature maintained thats it showing..

Is This Answer Correct ?

6 Yes

9 No

if we put any thermocouple on a table in a room without any connection,what temperature should it ..

Answer / ravi kumar

it will not react up to 28 degc so, it will not show any mv hence we have to check its continuity for working

Is This Answer Correct ?

2 Yes

11 No

Post New Answer

More Instrumentation Interview Questions

WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL? INSTEAD OF 4-20mA.

6 Answers Hindustan Unilever Limited, Yashmun Engineers,

what is the different between deflection type measurement and null type measurement in RTD?

0 Answers SHR Solutions,

why most of the DP transmitters using maximum range as 0-2500mmwc?why not 1000 2000 3000 4000mmwc

2 Answers SPIC, TNPL,

Advantages of servers over normal desktop in PLC SCADA system

1 Answers InfoMedia,

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

0 Answers Hospira,

can we use flow transmitter instead of level transmitter?

7 Answers

Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com

0 Answers

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers

how to calibrate ph meter?

3 Answers

What is the difference between Error and Offset.

1 Answers

please tell me how to convert double acting ytc positioner yt-1200 into single acting ytc positioner ?

1 Answers

How to get Cv of control valve having following parameter ,i.e inlet pressure 4.5kg/cm2 outlet pressure 1 kg/cm2 specific gravity 0.808

3 Answers

For more Instrumentation Interview Questions Click Here