Interested to Buy Any Domain ? << Click Here >> for more details...
if we put any thermocouple on a table in a room without any
connection,what temperature should it show.
- 3 Answers
- 7054 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak
as we know working principle of thermocouple , mv generation
is function of temprature difference between hot and cold
junctions, in above case we are keeping thermocouple on
table in room .means both junctions at same temprature hence
it should be shown zero temprature.for example,
if room have 30 degree temp.then hot -cold= actual temp
30- 30 = 0
| Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
what is function of sensor, and how is it work , explain with difination
this site is owned by an nonsense
Introduce yourself which is not present in your biodata?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is the working principal of pribe
What is the use of single seated valve?
Square root calculation for dp flow transmitter?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
what about your moleg in pogrees with company
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
components of control circuit belongs to control valve
