Answer / thambirajan

REYNOLDS NUMBER=INERTIA FORCE PER VISCOUS FORCE



REYNOLD NUMBER IS LESS THAN 2000 THE FLOW IS LAMINAR
MORE THAN 2800 THE FLOW IS TURBULAND

BETWEEN 2000 AND 2800 THE FLOW IS NEITHAR LAMINAR NOR TURBULAND

Answer / mustansir pancha

Reynold's number is the ratio of (density * velocity *
length) / (dynamic viscosity u)
It helps determine whether the flow is laminar or turbulent.
If reynolds number is more than 3000, then the flow is
turbulent in case of water.
It has no unit.

Answer / vignesh.p

Reynolds number is used to
find out the type of flow
ie.whether it is streamline or
turbulent...it has no unit

Answer / pkg

reynold number is dimension less number that is equal to ratio of inertia force to viscous force. Re tells about flow type tubulent(>4000) or laminar (<2000).

Answer / kundil phukan

It is the ratio of inertia force to the viscous force.According to reynold the transission from laminar to turbulent flow in a pipe depends on velocity,pipe diameter and kinematic viscosity of the fluid.At critical reynolds no of 2000 flow starts changing from laminar to turbulent

Device use to control flow rate of centrifugal pump.

2 Answers   RRB,

1.select bearing for flywheel to have a life of 5 years ? 2.select minimum diameter of the crank pin to work for at least 1 year? 3.select suitable belting to connect motor and pulley shaft(flywheel shaft)?

0 Answers  

which type of electrode can be used for welding hardox 400 to St37 ? and do i apply any heat treatment ?

1 Answers  

What causes friction in the cylinder?

2 Answers  

WHY MECHANICAL ENGG ARE RECRUTED IN IT COMAPNIES?

2 Answers   TATA,

what is the refrigerent

6 Answers   Blue Star,

stress strain diagram for fluid

11 Answers   NTPC,

What is an oil mist detector

0 Answers   RRB,

Lowest temp in vapour compression cycle in :(Ans:Expansion devices) Contineous welding is type of :(Seam Welding) refrigerant in domestic Refrigerator:(R 134 A) Lowest critical temp of refrigerant:(Freon) Statement....this is .....law:(Avagadros law) Ratio reynold no to prandtl no is:(Pecelent no) if welding is done from right to left then what is the name welding:(Not known) slip gauges are made up of:(alloy steel) clearence between meeting surfaces is due to which gauges: question on rubby laser,rake angle,heat treatment processes,joules law,bell coleman cycle like a/c works on which cycle?

2 Answers   Hitachi,

hardness of grinding wheel is specified by

8 Answers   NTPC, TATA,

interviw tips for bhel supervisor trainee

0 Answers   GIL, Jindal Steel and Power,

What are the different types of springs and explain them?

0 Answers