in power plant which pump is used for feeding the water
a) centrifugal pump or
b) reciprocating pump.
and why?
Answers were Sorted based on User's Feedback
Answer / sreekanth
Normally in high pressure boilers Centrifugal pumps are
used due to hich discharge
| Is This Answer Correct ? | 3 Yes | 1 No |
Generally both are used in the power plant ,depending upon
the capacity of plant.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / avishek bhattacharya
For feeding water to the boiler drum Boiler feed pumps are used.It is a multistage centrifugal pump,it is used because it has high discharge as well as high pressure( by multistaging)as it has to deliver water against the drum pressure and also the drum is loacted 60 m above ground.Discharge pressure is upto 20 mpa.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / tarang
reciprocating pump is used as water has to be pumped at high
head (pressure) and at medium discharge (or low)
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / arvind kumar shakya
in power plant need to high head of water centrifugal pump
| Is This Answer Correct ? | 0 Yes | 2 No |
What is latent heat of melting? What is latent heat of vaporization? What is difference b/w steam, wet steam, saturated steam and superheated steam? What is relationship of boiling point and pressure? What is mean by HP steam? What is function of HP steam system? What are main components of HP steam system? What is function of steam strainer? What are conditions for opening of warm up control v/v LBA10AA050? What are conditions for opening of turbine control v/v?
what is the diffrence bitween hypo eutectoid and hyper eutectoid steels?
6 Answers Bhel, Suzlon, TATA, Tech Mahindra,
what is little law and why it is so called?
why conservator contains 8% total oil qty in transformer any formula to calculate
how the ratchet in an micrometer works?
Which tools are used in fitting shop?
What does 0.125 inch stand for in 0.125 inch npt thread?
Srinagar is situated on the bank of the river
what is air intake system
what happens when the spark are introduced before the piston reaches maximum
why Flywheel is used (Need technical answer)? why generally flywheel is big in shape?
Q-1-what type of bearing used in system? Q2-MEANING OF BEARING SPECIFICATION-ZZ, C3,RS 2Z ZZNR
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)