the transient state stability limit of a system wherin power
is transmitted throgh a double transmission line is
(a)equal to steady state stability limit
(b)more than its steady state stability limit
(c)less than than its steady state stability limit
(d)equal to its dynamic stability limit



the transient state stability limit of a system wherin power is transmitted throgh a double transmi..

Answer / bhargavi bhumireddypalli

less than the steady state stability limit

Is This Answer Correct ?    7 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

can we say current flows inside an atom as electron moves inside an atom?

7 Answers   Vedanta,


If NO contact of relay gets supply from other sources or other part of circuit and at a time relay coil activates,then current will flow in which direction & will it cause to damage relay??

1 Answers  


Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?

0 Answers   IOCL,


How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?

0 Answers  


234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,

0 Answers   Jomel,






Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?

0 Answers  


difference between over current and over load protection?

5 Answers   BARC,


What is the basic difference among Circuit breaker,Contractor and Isolator? Are they different names of same device/equipment?

2 Answers  


What is power in wattage of 8.5 TR AC

0 Answers  


If load current is 70amps or 50amps what range of CT to install for ampere metering

3 Answers  


What is LCI drive & how does it work & why it is used?

1 Answers   EIS, ONGC,


what is the most probable reason of failure of current transformer?

2 Answers   L&T,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)