what is power factor

4 Answers  

---

WE are using a 63A MCCB(SIEMENS MAKE) for one of the feeder in LV substation panel.It is supplying to a lighting & power socket DB.Settings in the MCCB is Ir = 63 * 1 , Isd = 8 times of Ir , tsd = 0.5 sec( I2 t off). Sometimes this MCCB is tripping .But no trip in DB MCB. Can anybody tell me reason ? From where i can know about the MCCB settings?

5 Answers  

---

I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions

0 Answers  

---

what will happen ac motor give to dc supply

9 Answers   Areva, College School Exams Tests,

---

What are the basic properties of signal flow graph?

0 Answers  

---

how to calculate micom relay earth falt time and current sertting

0 Answers  

---

what is use of stater and choke in tube light.?

2 Answers   Aditya Birla,

---

what are factors to be consider to design a HT & LT motor?

1 Answers  

---

purpose of flux relay for turbo generator in power plant

1 Answers  

---

Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?

0 Answers   Accenture,

---

to calculate voltage drop of cable which current we consider that means full load current or panel size?

2 Answers  

---

During he starting up of the motor, the upstream's MCCB (350A) always trips due to the UVT relay activated. Can Star-delta starter use for a 20kW Motor (For a powder mixer machine) cause voltage-dip in the supply line voltage? If so, what are the recommended solution to eliminate/reduce the transient voltage dip in the line voltage?

4 Answers  

---