Is there any problem ,if R-Y-B voltage is constant , but the air compressor ta

Is there any problem ,if R-Y-B voltage is constant , but
the air compressor taking one phase high current.what is
possible causes.the said compressor is very new.(55kw).

Question Posted / sanjaymaven

4 Answers
7458 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Is there any problem ,if R-Y-B voltage is constant , but the air compressor taking one phase high ..

Answer / sushil

there may be a manufacturing defect such as 1)damaged or
bad insulation of that perticular phase 2)It may also the
alignment problem of the shaft of compressor

Is This Answer Correct ?

8 Yes

1 No

Is there any problem ,if R-Y-B voltage is constant , but the air compressor taking one phase high ..

Answer / kuldeep singh b.tech iitr

It may be due to winding problem. There may be different
winding resistance/induactance from the othe two one, of
that perticuler phase

Is This Answer Correct ?

5 Yes

0 No

Is there any problem ,if R-Y-B voltage is constant , but the air compressor taking one phase high ..

Answer / vijay kadlag

r y b voltage may be constant but frequency missing

Is This Answer Correct ?

4 Yes

2 No

Is there any problem ,if R-Y-B voltage is constant , but the air compressor taking one phase high ..

Answer / daxity

Obviously there is problem because the currents are not
balanced.the cause might be an imbalance in the winding
resistance which might come from unequal number of turns or
deffective insulation on that particular phase,or loose
connections on that phase from point of supply to the last
termination.........if the windings are perfectly
balanced:-misalignement and bearing failure can affect all
the phases.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is the vector group of a transformer,how can it be found out?

0 Answers Jindal,

what do u understand from filter factor of reactor?

0 Answers

How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers

why normally Generator rating are between 11Kv to 22Kv?

2 Answers IFFCO,

how many test is necessary for 27mva transformer.

3 Answers HEG,

I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?

0 Answers

Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV

0 Answers Bhel,

why we use shunt in a rectifier system ?

1 Answers

Why the high starting current does not harm the low capacity induction motor?

1 Answers

now a shunt motor is practically a constant speed motor , then how does it meet the increase or decrease in the load ?

1 Answers

how we can differentiate a motor and a generator just by a glance?

5 Answers

In distribution transformers, fuse wires are very thin when compared to conductor size. How it's possible?

4 Answers

For more Electrical Engineering Interview Questions Click Here