Answer / Trapti Kansal

The low earth resistance (ER) value of 9 Mohm for a distribution board feeder could be a cause for concern, as it might indicate a fault or issue with the wiring or grounding system. However, without more information on the specific equipment and operating conditions, it is difficult to determine the exact problem. It is recommended to consult with an electrical engineer or a technical expert for further analysis.

The importance of resonant filters in converters?

1 Answers  

---

What is meant by electrical speed?

1 Answers  

---

NOW A DAYS THE POWER SUPPLY IS VERY LOW.SO THE FLURESCENT TUBE LIGHTS ARE VERY DIM.IS THERE IS ANY WAY TO INCREASE ITS BRIGHTNESS?FOR EXAMPLE ANY CONVERTER,CONDENSER?

1 Answers   Bhel,

---

which type of amplifiers are used in multimete?

1 Answers   NTPC,

---

how much percentage set in transformer diffrencialrelay

1 Answers  

---

can anybody sent me power grid questions. what subject should i prefer for preparation?

1 Answers   Reliance, Vascon,

---

Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks

1 Answers  

---

Which type of power plant is more easier to produce electrical power at economical condition?

8 Answers   HAL,

---

we have one ups its neutral is not earthed.its one distribution MCB has a earth fault.but we can not put off any MCB.so how to find out that in which circuit is earthed without isolating the breaker.

3 Answers   CFCL,

---

where transformer is installed? a)generating station b)substation c)voltage regulating area

6 Answers  

---

i want to know how to calculate the battery capacity based on the UPS . ex i want to run have one kva UPS Which should run 10 hours ? in that case how many batteries to be installed and what will be the AH Value .

2 Answers  

---

who is invented transforner (230v).......

2 Answers  

---