What are the most immediate challenges of this position that
need to be addressed in the first three months?
Answer / rakesh.r
Immediate take over the job responsibilities and working as
professionals
| Is This Answer Correct ? | 0 Yes | 0 No |
WHY TORSION SHAFT IS GIVEN IN BALL MILL DRIVE. IS THIS HAS A ANY TECHNICAL REASON?
substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section? (a)1J, (b)75000J, (c)90000J, (d)25000J
What is the remedy if due exchanging, valve broke out during engine running operation?
what is boiler
how gearbox ratio was calculated?
What is BMS?
what is the difference between run out and ovality
if silica is removed from DM Plant completely from where the silica come in Boiler Drum
Q. what @the interview exact Q&A is it correct
What are the dimensionless parameters used in forced convection?
Which bearings are used in the reciprocating compressor?
2 Answers Manali Petrochemicals,
suppose if u selected ,when will u quit?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)