During the ISO/TS Certification Audit the auditor arise the
NC in the MRM dept.The NC is
MRM is not conducted effectively .
What is the CA for that NC?
No Answer is Posted For this Question
Be the First to Post Answer
what is difference between stress and pressure ?
Refrigeration cycle works on?
DURING STEAM BLOWING OF PIPE LINE, A BLUISH COLOR CONICAL PATTERN IS OBSERVED AT THE END OF PIPE. WHATS THE CONCEPT BEHIND IT?
if you are standing on 30th floor & you asked to drink a water through straw .can you? water is in glass at the ground floor.
What is bootrom? And how it works?
fan having rotational motion why
0 Answers TATA, Tata Steel Limited, Telco,
about basic questions ofpiping engg
what is purpose of governor in desiel engine...
If saturated temp of water is 99.8degc at atmospheric pressure,then how the water of sea is evaporated at normal temp 71
One litre is equal to ________cm3 ?
Explain how to measure crank web deflection?
what is difference between en8 and en24.if the usseage of motor shaft en8 what problems faceing?and what are the advantage of en24?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)