Answer / ashish

supercharging is a method to increase the air density at the inlet manifold and hence better aspiration of the engine.

Answer / anil kumar satri

THE BP DEVELOPED IN THE ENGINE IS DEPEND UPON THE AMOUNT OF
CHARGE ENTERING IN TO THE CYLINDER (VOLUMETRIC EFFICIENCY).
WE CAN DEVELOP THIS VOLUMETRIC EFFICIENCY BY TWO METHODS
1) SUPER CHARGING
2) TURBO CHARGING

SUPERCHARGING MEANS IT WILL COMPRESS THE AIR IN
COMPRESSOR, BEFORE SENDING INTO THE CYLINDER BY UTILIZING
THE POWER DEVELOPED BY THE ENGINE.

TURBO CHARGING MEANS ALSO SAME, BUT IT UTILIZES THE EXHAUST
GASES TEMPERATURE TO RUN THE COMPRESSOR.

Answer / franco ambrose s

Supercharging is the process of increase the inlet air
pressure.actually supercharging method is done in gasonline
(petrol engine )here separate battery is needed to compress
the inlet pressure.because the exhaust gas wont be high
pressure as in diesel engine.

Answer / franco ambrose s

It is used in gasoline engine which is used to increase the
inlet pressure of air before it gets
compressed.supercharger is coupled with crank shaft to give
the power to the compressor to compress the inlet air

Answer / m. arup(jitu)

TO RAISE THE VOLUMETRIC EFFICIENCY ABOVE THE VALUE WHICH CAN
BE OBTAIN BY NORMAL ASPIRATION.

Answer / lakshmikandhan.v

supplying air or air fuel mixture into the cylinder more
than atmosphere

Answer / kapil

to raise the temprecher above the value of temprecher requiered.

pls any one send me the last 5 years rrb QP - hari.devarajan@gmail.com

0 Answers  

Dear Sir, Please send me the questions frequently asked during bhel persoal interview for supervisor trainee With worm regards, Alok Kumar Rout e-mail id- rjdalok22@gmail.com

0 Answers  

What is the difference between s.s to en8

2 Answers  

Which outer cover is on the welding rod?

0 Answers  

How can I see where pipes are behind the wall?

0 Answers  

how bulk density can be calculated suggest with practicle example

1 Answers  

What is meant by direct heat exchanger [or] open heat exchanger?

0 Answers  

how to know the direction of a flow in a pipe line in a room without using pressure gauge?

1 Answers   ATS,

what is mechanical engineering?

6 Answers  

how do you come to know air is fully saturated

6 Answers   NTPC, SSB,

What is plant load factor?

1 Answers  

i want how the pattern of interview goes on for mahindra& mahindra company? plz send me as soon as possible

2 Answers