how to identify conection leads of an unknown electric motor
No Answer is Posted For this Question
Be the First to Post Answer
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
An 11kv system consisting of an underground cable to a sub station about 300 meters away was shut down for about 10 hrs. On energising, it tripped off on earth fault about 10---20 mins later 6 times but since than it is not tripping.its already 3 weeks now. The SPAJ was found to be fine. what could be the cause.No test had been done to determine the cause of the trippings till now because of demand.
What are the material used for inductance coil?
. Is there a simple method to measure the horsepower of a small motor (1-3 hp) for a non-technical person
why in america the supply frequency is applied as 60 HZ. but in india we use 50 HZ.
1 Answers Elcom International, HCL, NTPC, OMC,
What is Grounding?
What is the function of RCCB? What are the different sensitivity ratings & each application?
from 33kv to 440v 2mva transformer how much full load current will be at ht side and lt side and which range of ctpt will be used?
Why the power factor improvement is so important in industrial loads
What is the difference between electrical earthing and electrical grounding?
why we calculate only 11kv 33kv and 132kv ... why not 10kv 20kv 45kv?