Answer / praveen saini

Cam is basically used for the opening and closing of the valve in a definite time which depend upon the profile of the cam..one of the cam is used in car engines head to enter (discharge) the fuel (exhaust gases)into the cylinder which is operated by the accelerator peddle.

Answer / guest

cam is a device which is used to operating the valves

Answer / satyawan

Cam is use for provide the reciprocating motion.

What is the basic difference between honing and boring.

0 Answers   Ashok Leyland,

---

What do you understand by Newtonian Fluid? Where is it used?

0 Answers   Ashok Leyland,

---

The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the engine rating required for 1000 KVA Generator set. Calculations?

0 Answers  

---

face to face first interview for the post of service engineer to question

0 Answers   Ashok Leyland, TATA,

---

Can Cpk value be zero?

3 Answers   Atrica, Pricol,

---

What is the reason for emitting the white exhaust smoke during start of the vehicle? How will you prevent this?

0 Answers  

---

What will you do if you are offered higher salary at a different organisation while you are working with us?

0 Answers   Ashok Leyland,

---

What is Terminal Engine Meltdown?

1 Answers   John Deere,

---

State two to three differences between two stroke and four stroke engine?

0 Answers   Ashok Leyland,

---

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

how to calculate 500 k.v.a diesel generator efficiency

0 Answers   Cummins, TATA,

---