Interested to Buy Any Domain ? << Click Here >> for more details...
In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact,
a) Direct gear is obtained
b) Second gear is obtained
c) Third gear is obtained
d) Reverse gear is obtained
- 0 Answers
- 1252 Views
- Backbone, Bosch, MAHINDRA, Uniparts Group, I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
Why front wheel is bigger than rear wheel in tractor?
What purpose to use damper pulley to engine?
Do the design & fittings depend on the type of the vehicle engine? Why is petrol used for engines only & vice versa.
What is diff between SCADA nad DCS,Present which is new technology, Is dcs controls with out manual operation?
which gas is used in cars and formula1 cars?
2 Answers Automobile, Hyundai, Tata Motors, Time,
What is Brinell's hardness test ?
What is the size of the recommended compressor cfm? Where it can be used?
Why do you want to change your present company??
The torque transmitted by a clutch is given by a) T = μWR b) T = μ/WR c) T = μW/R d) T = 1/μWR
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What are different types of dies?
Will engine performance be damaged by mixing oil in fuel of four stroke bike ?
what is the formula for calculating BHP IN SI UNITS
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
