Answer / raji g

if a spark take a path on the air that is called arc..
normally spark occurring time less than that of arc time

Answer / sanjay kumar shrivas

In both case the dielectric strength of the air gets break and because of that so many ions ll come into the picture... And those ions will provide a conducting path..thats why we use to see spark or arc..... But the difference between arc and spark is totaly related to the duration for which they are occuring...spark is for short time and arc is for long time

how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence

0 Answers  

---

how to convert single phase supply to 3 phase or 3 phase to single..?

7 Answers   Wipro,

---

oil cooled transformer

0 Answers   Jindal,

---

why should the primary of transformer be connected in delta in a heat run test?

0 Answers   Bhel,

---

Why dose an electric meter record KVA when there is no load on a 500 KVA transformer

1 Answers  

---

While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?

0 Answers  

---

What is the use of insulation tester and how it is to be used.

2 Answers  

---

At present how many HVDC lines are there in india

18 Answers   HAL, Infosys, KSEB, Kuntham,

---

what is meant by armature reaction?

13 Answers  

---

What is transformer break down voltage.And what is flash oil flash point.

1 Answers   HP,

---

if the rotor of induction motor is purely inductive then what is the electromagnatic torque.........

1 Answers  

---

We all have seen transmission and Distribution lines In transmission lines the voltage is high and current is low(to reduce I^2r loss) and in distribution lines voltage is low but current is high however the size of transmission wires is bigger than that of distribution wires even though the amount of current carried by the distribution lines is more than that of transmission lines why?

4 Answers  

---