Answer / shamim

Its depands on part of the building to be use,ie
raft/footing,slab,col. etc.

Answer / mr. ajay kumar singh

Normally reinforcement use in residential building- 5 Kg/Sqf & 53.82 Kg/ Sgm.

Answer / noorul haq

Steel-Reinforcement in RCC Structure of G+12 Residencial
Building is 52-60 Kg/smt.

Answer / shahnawaz

really its depends on the structure of the building

Answer / nantha

20 to 30 kg /s qm

Answer / anvesh

weight of steel =7.85kg/m^2
hence for 1m^2
the quantity of steel=(7.85kg/m^2)/(1m^2)=7.85kg of steel

Answer / nitin ghamdayan

Steel may be calculated@ 18 kg per sq.m

Answer / rakesh jangra

its depend on soil test and there zone
normal for rb- 3 to 4 kg /sqf
and for cb- near about 0f 7kg/sqf

Answer / jaikumar

80 to 120 kg

Answer / bablu ghule

60 to 70 kg/sqm

what are the differences between Tie beam, Ground beam and strap beam. thanks

1 Answers  

How much standard bricks required for a wall of 9*1200*1200 inches

1 Answers   ABC, L&T,

i know that, the for calculating material required for concrete volume of concrete is taken 50-54 % more for wet volume. i have querry is that cement and sand volume taken more for making wet volume but in the case of aggregate why it is taken more there is no change in aggregate whether it is dry or wet.???? can you give me answer for this???

0 Answers   QRI,

Rust in Rod is harmful in structure because -––

1 Answers  

how much should we assume for the weight of foundation ??

1 Answers   Unitech,

Lap length may different for FE 415 and FE 500 Steel, If different what is the different, In which code is mentioned

3 Answers   Bestech,

What are the Tests required to check the Quality of bar?

3 Answers  

what is quick sand

4 Answers  

how to consider the lap length of a bar in IS code and specify the code book name and clause& page number?

2 Answers  

how can we calculate the cutting length of 10,12,16,20 and so on iron bars for 45 digree and 90 digree bents plz tell me if there is any formula or tabel to find it

14 Answers   Anukampa Group, AZ Engineering, L&T, Navayuga,

what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix

1 Answers  

1 building project (work in progress) and following are sum detail about his project 1) Using local rebar grade 415 2) Total built up area- 60000 sq.ft 3) Floors to be constructed – 21 storey 4) Estimated requirement of Steel per sq. foot – 7KG/sq.ft 5) Concrete grade – M35 6) Rebars mainly required (sizes)- 16,20,25,32 & (8 mm for stirrups) Wanted to ask u if this person uses 500D…what are the benefits he will be getting? Whether his per Sq. foot consumption can b reduce? If yes den around how much?

1 Answers