In our plant we are having 6.6 v motor wih MV drive running frm last two years

In our plant we are having 6.6 v motor wih MV drive running
frm last two years.udenly at some speed motor getting vey
vibrations what is the problem

Question Posted / anji_p27

2 Answers
4264 Views
ITC Infotech, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In our plant we are having 6.6 v motor wih MV drive running frm last two years.udenly at some spee..

Answer / anurag pattanayak

could be resonance...try skipping the critical speed...

Is This Answer Correct ?

0 Yes

0 No

In our plant we are having 6.6 v motor wih MV drive running frm last two years.udenly at some spee..

Answer / brdganesh

May be hunting (due to failure of damper winding)

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Why capacitor blocks DC current?

2 Answers

If there is no problem with the electronic circuit and regulator then why the motor start rotating at low value of regulator with full speed both at laod and no load??? and if my judgement of circuit is wrong then what is your openion?

1 Answers

why in isolation transformer we dont get any shok?

2 Answers

IF THE OUTPUT OF A 100KVA, 415V GENERATOR IS STEPPED UP TO 11KV WITH A 500KVA TRANSFORMER,CAN THE TRANSFORMER BE LOADED ABOVE THE SOURCE GENERATOR RATING?

4 Answers

why moisture formation found in XLPE Armoured cable outer sheath

0 Answers

What is the difference between grid and off- grid system??

0 Answers GVK,

What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?

0 Answers

To generate electricity , what is the speed of rotor?

1 Answers JEC,

If we have 630kva step down transformer to operation 3 phase motor 150 kva which size of cable is used? at circuit breaker to 3 phase motor or to electrical board

1 Answers

IN dc capacitive reactance is??

0 Answers

how the harmonic pluses take place in the flow of current

2 Answers

An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?

0 Answers HAL,

For more Electrical Engineering Interview Questions Click Here