In our plant we are having 6.6 v motor wih MV drive running
frm last two years.udenly at some speed motor getting vey
vibrations what is the problem
- 2 Answers
- 3467 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / anurag pattanayak
could be resonance...try skipping the critical speed...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to set a Zone 1 distance relay for distribution feeder?
Can we put 3 layers of cable tray while installing tray
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
What is the necessary condition for stability.
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
How to improve fuel cell in a distribution system?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Define filter?
why not starting switch first connect in direct on line starter?????
Can any body tell gulf interview question for experienced electrical engineer ?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
What is Traction? 1KVA Alternator, How much urrent taken?
what are the steps involved in generator load test?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
