Interested to Buy Any Domain ? << Click Here >> for more details...
where AVR is connected in power plant.
- 7 Answers
- 13193 Views
- ABB, Saudi Red Bricks, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ishwar shivanand dematti
RTCC Panel :-REMOT TAP CHANGING Control panel
| Is This Answer Correct ? | 11 Yes | 3 No |
Answer / nitin bhoraokar , power plant
Yes. AVR is required for voltage regulation. AVR regulates
terminal voltage of generator automatically. Now-a-days
digital AVRs are preferred.
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / k.prakashchandra
Excitation equipment which itself is called AVR or DVR In
old type, AVR was provided in control panel.
| Is This Answer Correct ? | 4 Yes | 3 No |
Answer / jeyapal
AVR is actually a PID Controller operating on a set point ,receiving a feed back sample of output voltage of an alternator and comparing with set point.Maintains output voltage and power factor by regulating the excitation level.Construction looks very simple in the form of a printed circuit board located just on the alternator or at times inside switch board panel with a cable run to the generator.
| Is This Answer Correct ? | 0 Yes | 0 No |
What are the components of feedback control system?
What is the settings of distance protection relay in 400 kv line
why the genearation of electricity always in form of sine wave only ??? why not cosine wave ???
What is the difference between class0.1 and class 0.1s accuracy of current transformers
Which motor has more efficiency ;Synchoronous or Induction motor ?
Difference between ac parallel circuit and ac series circuit?
how to select earthing conductor size of amy motor/panel etc.
why ahould you show client/engineer activities clearly on the project plan
What is the difference between ground and neutral ?
What is the speed of electrical supply?
when power transformer is flashed which gas is produce in side?
when meggering a 3ph,480v oil reservoir heater on a regen gas compressor, why do I get a reading to ground when meggering phase to ground? shouldn't it read opened or is there something that makes it read closed? on the same heater, when ohming, it reads open. thanx
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
