Answer / alu subal m s

commutator is part of the alternator,which converts AC current
to DC current

wat happens if u use petrol in diesel engine

13 Answers   Ashok Leyland, Infosys,

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

basic difference between bsIII & bs IV

2 Answers  

---

PPAP - VDA full form

2 Answers   Kyungshin Industrial Motherson Ltd, Tenneco,

---

In a constant mesh gear box, when the right dog clutch is engaged with the gear on the right side of the main shaft, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

Tell me about a time when you surmounted a major obstacle.

0 Answers   Ashok Leyland,

---

For the second gear in a synchromesh system, the drive transfer will be through a) U1, U2, C, F2, and splines b) U1, U2, C, F1, and splines c) U1, U3, D, F3, and splines d) U1, U4, U5, E, F2, and splines

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What High School Career completer should you select, for automobile engineering?

0 Answers   Nissan,

---

what is alignment?

1 Answers   ITI,

---

What do you understand by Newtonian Fluid? Where is it used?

0 Answers   Ashok Leyland,

---

Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!

0 Answers   OBDmore,

---