Is it possible to protect 3phase overload and earth fault
of the 3phase system using two CT's.
No Answer is Posted For this Question
Be the First to Post Answer
what's mean by Transient stability analysis?
Y phase plates are used in transmission line??? what is there need???
Why the transformers are rating in KVA.?
If cvt is most advance & effective(economically & stability)so why not use instead of VT(11 kv & 33 kv)?
How to increase the backup of three phase ups?
How to write a progrramme to turn ON and turn OFF a motor with a single push button in AB?
2 Answers HCL, Torrent Pharma,
MCB is used for high rating &MCB is used for lower rating.What is technical difference between ACB & MCB?
in a three pin socket y the pin of earthng is longer n bigger...?
at the time of starting back emf of a motor is zero.so how can it will start to run??
Current chopping mainly occurs in air blast circuit breaker.why?
What is the differance between negative dc voltage and positive dc voltage because some circuit uses -24,-5,-12,- 15,volt dc supply
10 Answers eLab, Hero Honda, NTPC, Suzlon, Teradyne,
We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?