If Ac supply is given to the DC motor then what will happen? clear explanation

If Ac supply is given to the DC motor then what will happen?
clear explanation

Question Posted / shivaram

2 Answers
4951 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If Ac supply is given to the DC motor then what will happen? clear explanation ..

Answer / rohit bharadia

it will depends on construction of motor;
if field winding is in series with the armature winding
then it is like a universal motor and it will run as a
simple motor.;
but field winding is in parallel with the armature winding
then it will not run, but current will flow in winding due
to this heatting will produced and the motor/winding car
burn.

Is This Answer Correct ?

14 Yes

0 No

If Ac supply is given to the DC motor then what will happen? clear explanation ..

Answer / munissamy.p

ac supply power is p=vicos
dc supply power is p=vi
poer is unbalanced otherwise dc supply frequency is 0.

Is This Answer Correct ?

2 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

What is the formula to calculate a three phase alternator

0 Answers

How to measure the earth resistance value in a concrete pavement(flood light area)?

0 Answers ANZ, Watt,

We operate a 10 Mw facility and we have been experiencing several trips due to fluctuations on the MVAR? We have checked all issues related to the AVR and we have found all OK? Can anyone help us? The grid voltage, internal voltage, all regular parameters look ok. MVAR fluctuate and there it goes the unit? What could be happening? Thanks!

5 Answers

why is only third harmonics is dangerous for electrical equipments?

3 Answers

what take 100 w take current

1 Answers SoftLogic,

how to calculate transformer turn primary & secondary side 11kv to 420v

0 Answers

I have connected 04nos. earthings to a transformer through 04nos. earthing pits seperately. 02nos. earthings are connected to T/F body, and 02nos. earthings are connected to T/F neutral.T/F capacity is 2000KVA, 11KV/415V. But after completing of 02 years successful operation ,we are facing following problems- 1. CT/PT occured blast one time 2. HT cable box occured blast two times 3. One body earthing strip and one neutral earthing strip of transformer are overlapping at some places. Whenever these two strips are pressed at overlapped points, they made spark. What is the reason of spark? Please explain the reason & rectification of above problems

5 Answers

What are the different types of controllers?

0 Answers

is the secondary voltage of current transformer greater than primary voltage,,,,,,,,] give the example with ct burden,current ratio,and primary and secondary side voltage?

2 Answers

what are the interview question asked in wind mill about electrical

0 Answers

WHAT IS THE DIFFERNCE BETWEEN AIS AND GIS IN SWITCH GEAR?

5 Answers L&T,

Why reverse relay used

2 Answers cpgn,

For more Electrical Engineering Interview Questions Click Here