Answer / ankush

A control t/f is one which gives constant o/p voltage and
current , so known as control t/f.
These are basicaly used in electronics circuits.
while PT are used for the measurement of voltages.
so simple......

Answer / k.prakashchandra

PT/VT are voltage measurement.Control Tr is for supplying
power to control or auxiliary equipments which can not be
used on regular available supply.

Why we can't start a tube light without a starter(choke) and an inductor?

1 Answers  

---

purpose of flux relay for turbo generator in power plant

1 Answers  

---

What is Earth Fault and Over current Fault.

1 Answers  

---

How to check phase R,Y,B

3 Answers  

---

How much should be the specific gravity of a DG set battery Electrolyte.

2 Answers  

---

ht side line to earth voltage

0 Answers   JLL,

---

Multimeter show phase to neutral volt 230 the per phase but phase to phase 415 not show 460 why.

1 Answers   Intas,

---

My meter ratio is -/5 and ct ratio is 100/5 now what will be the multiplying factor and how ?

1 Answers  

---

why rating of motor in HP

2 Answers   MSL,

---

Spacing of Transformers ratings are 10kva,15kva,25kva,63kva,110kva,150kva .........so on Q) Why transformer are not manufactured having ratings in between or other than these standard ratings ?

3 Answers  

---

what is the Auto Mains Failure Panel function in DG?state its function?

3 Answers  

---

what are the reasons for overheating in electrical machines?

3 Answers  

---