Answer / Gaurav Pandey

1. Standard of DCS Panel Design: The standard for Distributed Control System (DCS) panel design varies depending on the manufacturer, but common standards include IEC 61131-2, NEMA 1, and NEMA 4X.n
2. Steps of DCS Panel Design:n a. Determining the layout: Identify the components required for the control system and determine their placement on the panel.n b. Wiring: Wire the components according to the manufacturer's specifications, using wires and connectors that meet industry standards.n c. Programming: Write the program code to control the DCS using a programming language such as Ladder Logic or Function Block Diagram.n d. Testing: Test the panel to ensure it functions correctly and meets performance requirements.n e. Installation: Install the panel at the site and connect it to the other components of the DCS system.n
3. Type of Connector: Common types of connectors used in DCS panels include screw terminals, DB (DIN rail) terminals, and spade terminals.

what are turbo generators?

1 Answers  

---

i saw in my company drawing seat cable size as mensioned like this 12p*15 sqmm,12t*1.5sqmm, 9c*1.5sqmm. now what my que is what is mean by p , t , c.

3 Answers  

---

Can DP transmitter with orifice plate works on Beta ratio 0f 0.3 and differential pressure of 100 MMWC in liquid service application?

1 Answers  

---

what is span value and zero ? and how set ?

1 Answers  

---

calibration of instruments.

11 Answers   ONGC,

---

Describe the function of Accumulator into the Pump

1 Answers  

---

If hart communicator provide 4-20ma source to any transmitter during the callibration?

3 Answers   Hyundai,

---

wt is cold junction compensation

1 Answers  

---

there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.

1 Answers   GATE,

---

can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know

0 Answers  

---

How would i calibrate a new commissioned flow transmitter???

3 Answers  

---

how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?

1 Answers  

---