Answer / parmar jayesh

yes

Draw bode plot of any transfer function. Why is plotting bode necessary?

0 Answers   L&T, STS,

---

Shall we get the reading on level transmitter only by termination,without commissioning?

1 Answers  

---

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

What is procedure on mmwc in to tph

2 Answers  

---

why we use -ve voltages in vibration prob?

1 Answers  

---

What is two wire system and how it work

2 Answers   Bhel, IFFCO,

---

selection criteria of control valve? and selection criteria of actuator explain in brief?

0 Answers  

---

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

---

Can I calibrate the Electromagnetic Flow Meter on line and How.

0 Answers   SEWA,

---

Can someone give a detailed chart on the temperature ranges which can be measured by various temperature sensors.

3 Answers  

---

any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com

0 Answers  

---

which is the best type to measure level of a Tank(water). Displacer or Differential Pressure method?

2 Answers  

---